NEC N8151-46 User Manual page 83

• The screws needed with the 5.25-in and 3.5-in devices are the same.
• Always use the screws that are provided with this device. The screws that
are provided with this device are metric screws (length: 5.0 mm; length
below washer: 3.5 mm). Using screws that are longer than the screws that
are provided with this device could result in damage to the device.
2
Connect the cables to the drive as
shown here.
Important
• Confirm the SCSI ID and other settings before installation.
• The factory default setting of the SCSI ID is 4. Make sure this ID is not used by any other
device in the system.
• This unit does not have a built-in terminator. When connecting this unit to the last terminal of
the SCSI bus terminal, attach a terminator to the end of the SCSI cable.
3
Attach the cover to the basic processing unit. Plug the power cable to the outlet.
4
Turn on the basic processing unit.
Front cover
Rail
Fig. 3
3.5 mm
metric screw
DC power cable
(unused power
supply connector in
the computer)
SCSI interface cable
Built-in AIT 81