Xerox DocuPrint 4890 Manual page 25

Unloading the
stitcher/stacker
tray
Guide to Performing Routine Maintenance
NOTE: A false tray full condition may occur when you
remove small stapled sets without pulling the tray out. The
counter is not reset, causing the printer to stop before the tray
is actually full.
The stitcher/stacker tray holds 2000 sheets (unstapled) of 20-
pound or 80 gsm paper.
To unload the stitcher/stacker tray:
1. Lift the black handle on the outside of the tray.
1. Tray handle
2. Stacker arms
2. Carefully slide the tray up and out and remove the printed
pages.
NOTE: A false tray full condition may occur when you
remove small stapled sets without pulling the tray out. The
counter is not reset, causing the printer to stop before the tray
is actually full.
3. Close the tray by sliding it back under the stacker arms.
Output trays
1
2
2-3