Adler Europe AD 7967 User Manual page 6

not to discolor the glass cover (B).
2. Connect the DC plug of the power adapter to the device's DC connector (I) on the underside of the device.
3. Add water to the water tank (E) do not exceed the maximum water level of 130 ml - figure 2B. Only tap water or purified water is
suitable for this product. Do not add water during use when the device is running. Only add cold or lukewarm water. Pour the aroma oil
into the water tank. The recommended dose is 2-3 drops per 130 ml of water. Essential oil can cause discoloration. If it accidentally
spills, wipe it off quickly with a cloth.
NOTE: Do not block the spray nozzle to avoid damaging the product.
4. Replace the splash guard (B) included in the package, then replace the top cover (B) vertically so that the diffuser is tightly closed -
figure 2C.
Note: The top cover (B) should be closed before use.
5. Connect the plug of the AC adapter to the power socket, the device is now in standby mode - figure 2D.
MIST ADJUSTMENT: Power button G1.
- Press the G1 button once, the device sprays the mist continuously until the device turns off automatically due to the consumption of
water previously poured in.
- Press the G1 button again, the device will switch to intermittent mode. It will alternately produce mist for 15 seconds and stop producing
mist for another 15 seconds. The cycles will repeat until the water in the tank runs out, then the device will turn off automatically.
- Press the G1 button a third time: the machine stops generating mist.
BACKLIGHT ADJUSTMENT: G2 button.
- Press the "LIGHT" button (left button) once: you will turn on the 7 color backlight alternately
- Press the backlight button (left button) again "LIGHT": continuous illumination of the last of the 7 colors displayed
- Press the light button (left button) "LIGHT" a third time: the light will be turned off.
To turn off the device, hold down the G1 power button for 2 seconds.
6. If there is no water in the water tank (E), the diffuser will be turned off automatically even when you press the spray button.
7. The product cannot be used if there is no water in the container (E).
NOTE: Mist concentration may vary slightly, which is normal. Different types of water, humidity, temperature and air velocity affect spray
intensity.
8. Before replacing with another oil, please clean the device according to the maintenance instructions.
9. Never leave water in the tank (E) when the appliance is not in use.
10. After working for a long time, turn off the device for 60 minutes to avoid damaging the ultrasonic wave chip, and then restart it.
11. The device is equipped with overheating protection. The device will automatically shut down if abnormal overheating occurs, the
safety feature avoids deformation of the product due to high temperature.
ACCIDENTAL LEAK
If you accidentally tip your device over while in use, follow these steps:
1. Turn off the power. Unplug the machine and open the top cover (B) to pour out all the remaining water from the water tank (E).
2. Gently shake the unit to drain water from inside under the drainage side (J).
3. Air dry the device in a safe place for 24 hours.
DESCALING
If there is limescale build up in the aroma diffuser caused by water, you can add white vinegar to the water to dissolve the limescale,
then rinse with water. Then use a soft cloth to wipe off the water. Never use strong cleaning agents.
6