Dometic 878HU-WH Installation And Operating Manual page 8

Installing the awning
Impact or pinch hazard
• Rapid casting spin off may occur. Spring tension will attempt to close
the awning quickly and unexpectedly.
Do not remove the nail from the torsion rod (at end cap) until both top
castings are secured to the corresponding main arms, and the awning
safety lock lever is in roll down position.
Straighten, remove, and discard the nail from the left end of the
torsion rod only.
!
CAUTION! Failure to obey these cautions could result in minor or
moderate injury.
Health hazard
• Use proper lifting technique and control when lifting the device.
• Maintain a horizontal distance of at least 410 mm between the fully
open awning and any permanent objects.
A
NOTICE! Damage hazard
• Ensure that the awning rail is parallel to the RV floor, and is not warped
or curved before installing awning fabric. If the awning rail is not
straight, the awning fabric may wrinkle or stretch.
• Install back channels on a flat surface, level, and keep parallel with
each other to ensure correct function and appearance.
• Use sealant after cleaning the parts and surfaces where fasteners enter
the RV's roof and/or walls to prevent moisture from entering.
• Observe the sealant manufacturer's instructions.
I
NOTE
• A stepladder may be necessary to reach awning rail.
• Make sure arm assemblies do not restrict use of doors, windows, etc.
• It's recommended 2 people install the awning. There are instances
detailed in the installing instructions that require 3 people to fit the
awning.
8
Dometic8700
EN