Advertisement
Quick Links
USA
SERVICE OFFICE
Dometic Corporation
1120 North Main Street
Elkhart, IN 46514
CANADA
Dometic Corporation
46 Zatonski, Unit 3
Brantford, ON N3T 5L8
CANADA
For Service Center
Assistance:
Visit:
www.eDometic.com
INSTALLATION
INSTRUCTIONS
REVISION A
Form No. 3312890.000 5/17
(French 3312921.000_A)
©2017 Dometic Corporation
LaGrange, IN 46761
Residential Patio Awning
8953001.400# Basement Hardware
8953002.400# Standard Hardware
Fabric Roller Tube Assembly
This manual must be read and
understood before installation,
adjustment, service, or mainte-
nance is performed. This unit must
be installed by a qualified service
technician. Modification of this
product can be extremely hazard-
ous and could result in personal
injury or property damage.
Important:
stay with unit. Owner read carefully.
FOR
945(XX)(YY).(X)00(#)
Lire et comprendre ce manuel avant de
procιder ΰ l'installation, ΰ des rιglages,
de l'entretien ou des rιparations.
L'installation de cet appareil doit κtre
effectuιe par un rιparateur qualifiι.
Toute modification de cet appareil
peut κtre extrκmement dangereuse et
entraξner des blessures ou dommages
matιriels.
These Instructions must
RECORD THIS UNIT INFORMATION FOR
FUTURE REFERENCE:
Model Number
Serial Number
Date Purchased
Model
945(XX)(YY).000#
FRTA
895300(X).400#
Hardware
Advertisement
Related Manuals for Dometic 8953001.400 Series
Summary of Contents for Dometic 8953001.400 Series
- Page 1 Model 945(XX)(YY).000# INSTALLATION FRTA INSTRUCTIONS 895300(X).400# Hardware REVISION A Form No. 3312890.000 5/17 (French 3312921.000_A) Important: These Instructions must ©2017 Dometic Corporation stay with unit. Owner read carefully. LaGrange, IN 46761...
-
Page 2: Safety Instructions
Read and understand ALL of the follow- ing steps before beginning installation. UNDERSTAND SIGNAL WORDS Application The Dometic Awning is designed and intended for use on A signal word , WARNING OR CAUTION is homes. used with the safety-alert symbol. They give the level of risk for potential injury. - Page 3 895300(X).400# Residential Patio Awning Installation Instructions Installation Instructions Specification Chart Installation of Dometic Awnings will briefly re- 8953001.400# 8953002.400# quire three people. Use the following procedure 62 3/4” 66-7/8” to assure a properly installed and properly func- 60-3/4” 64-1/4” tioning awning.
- Page 4 895300(X).400# Residential Patio Awning Installation Instructions FIG. 5 Personal Injury Hazard. Rapid casting spin off and rapid arm extension will occur if they are not controlled. Before separating torsion from hardware, the torsion must be pinned through end cap and hardware arms must be bound.
- Page 5 895300(X).400# Residential Patio Awning Installation Instructions After FIG. 7A Before 8953002 Standard & 8953001 Basement Hardware FIG. 8B FIG. 8A A w n i n g Rail Top Brkt Fabric Top Brkt Roller Tube Assembly Bolt, lock Nylon Nylon Washer, & Front Spacer Channel...
- Page 6 895300(X).400# Residential Patio Awning Installation Instructions 3. Drill four (4) 3/16” holes through the outside wall using the holes on the back channel as a guide. See FIG. 1. Do not place unit on or near to sources of 4. Secure each back channel to wall with four (4) heat.
- Page 7 895300(X).400# Residential Patio Awning Installation Instructions F. Initial Awning Adjustment 1. Before the left arm assembly is removed the tor- Important: sion must be pinned to prevent uncontrolled un- Rapid cycling of the awning (opening & winding of the spring. closing) can cause the motor to overheat.
- Page 8 895300(X).400# Residential Patio Awning Installation Instructions Keep a tight hold onto the crank while the cot- ter pin is pulled out of the end cap. g. Slowly unwind spring tension by allowing the spring to unwind counter clockwise. Torsion will want to unwind by itself. Caution should be taken to prevent rapid unwind.