Table of Contents
Advertisement
Quick Links
USA
SERVICE OFFICE
Dometic Corporation
1120 North Main Street
Elkhart, IN 46514
CANADA
Dometic Corporation
46 Zatonski, Unit 3
Brantford, ON N3T 5L8
CANADA
This manual must be read and
understood before installation, ad-
SERVICE CENTER &
justment, service, or maintenance
DEALER LOCATIONS
is performed. This unit must be
Please Visit:
installed by a qualified service tech-
www.eDometic.com
nician. Modification of this product
can be extremely hazardous and
could result in personal injury or
property damage.
INSTALLATION
INSTRUCTIONS
REVISION A
Form No. 3308192.016 10/16
©2016 Dometic Corporation
LaGrange, IN 46761
WeatherPro Hardware
855(X)004.40(X)(X) 5th Wheel Standard Hardware
8(X)5(XX)(XX.XX)(X)(X)
Fabric Roller Tube Assembly
Important:
These instructions must stay with unit.
Owner read carefully.
FOR
Lire et comprendre ce manuel avant
de procéder à l'installation, à des
réglages, de l'entretien ou des répa-
rations. L'installation de cet appareil
doit être effectuée par un réparateur
qualifié. Toute modification de cet
appareil peut être extrêmement dan-
gereuse et entraîner des blessures ou
dommages matériels.
MODEL
8(X)5(XX)(XX.XX)(X)(X)FRTA
855(X)004.40(X)(X)
Hardware
Advertisement
Table of Contents
Related Manuals for Dometic WeatherPro 855 Series
Summary of Contents for Dometic WeatherPro 855 Series
- Page 1 MODEL INSTALLATION 8(X)5(XX)(XX.XX)(X)(X)FRTA INSTRUCTIONS 855(X)004.40(X)(X) Hardware Important: These instructions must stay with unit. REVISION A Owner read carefully. Form No. 3308192.016 10/16 ©2016 Dometic Corporation LaGrange, IN 46761...
-
Page 2: Safety Instructions
Application tential for personal injury. The Dometic Corporation awning is designed and intended for use on Motorhomes, Travel Trailers, and Fifth Wheels with straight sides. Follow recommended precautions and safe operating instructions. -
Page 3: Installation Instructions
Installation Instructions Specification Chart 855(X)004.40(X)(X) 67-1/4" 63-11/64" Installation of Dometic Corporation awnings will briefly 63-15/16" require three people. Use the following procedure to as- 3/4" sure a properly installed, and properly functioning awning. 65-1/2" 65-1/2" Secure FRTA to Hardware 1-5/32"... - Page 4 FIG. 4A FIG. 4B AWNING FIG. 3 RAIL FABRIC ROLLER BEFORE ASM. TUBE ASSEMBLY Back Channel NYLON NYLON Pin & Roto Clip AFTER Spring Loaded Bottom Arm A third person is now required to feed the fabric into C. Using one (1) 1/4"-20 x 3/4" hex head bolt, one spacer the awning rail.
- Page 5 30 degrees F. and turn switch back on. If alarm is still sounding contact Important: Dielectric grease must be placed on all a Dometic Service Center or a qualified service technician exposed pins. for assistance.
- Page 6 5. Back Channel And Bottom Bracket Installa- 6. Initial Awning Adjustment tion A. Cycle the awning four or five times to check fabric alignment and to make sure the hardware is nest- ing properly. If there is a misalignment, adjust the arm Important: Structural backing (metal) is required by loosening the upper mounting bolts and move...
Need help?
Do you have a question about the WeatherPro 855 Series and is the answer not in the manual?
Questions and answers