Advertisement
INSTALLATION METHOD
- Tools you will need - Phillips head + driver (manual or motorized) / 8 mm socket wrench / Level / Stud finder / Drill.
You may also need an Ø 4 mm drill bit for wood (or steel) or an Ø 8 mm drill bit for concrete.
- The actual product may differ from the picture.
Fixating the mounting bracket on the TV
1
- If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and
refer to the technical service manual.
Guide spacer
2
How to attach to masonry walls
Please follow the below direction.
- Check the material and thickness of the wall.
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow
block that do not crack.
- When installing the product on a wooden wall, refer to page 5.
- When installing the product on wall material not designated, install the product so that each fixated location can withstand a pull
out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
b
- Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
a. Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm to 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm to 60 kgf/cm.
How to install the wall mount
3
<When installing on a masonry wall>
→ When you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall, it is much
easier to install the product.
A
4
Guide spacer screw
42LB55/56*/58*/65* Model
Wall mount screw
(TV Accessories)
* Assemble the wall mount screws provided with the TV, the guide
spacers, and the guide spacer screws provided with the wall
mount in the order shown in the drawing.
* Insert the wall mount screws into only the two holes near the top
of the TV. Tighten the screws.
c
A
Separate the wall mount screw.
Guide spacer screw
Guide spacer
Anchor
d
→ When installing the product on a masonry wall, turn the
8 screws on the A part counterclockwise to separate the
screw and bracket.
→ After aligning the wall bracket to the location to install,
mark the part to screw on the wall and then remove the
wall bracket.
→ Use a level to check whether the wall mount is level.
<Work procedure>
1. Check to see if the display has
screws installed into the mounting
holes. If so, remove those.
2. Assemble the guide spacer and the
guide spacer screw in order as
shown in the picture.
- Assemble the guide spacer to the
set by tightening the screw.
- Tighten the screw until the set,
guide spacer and the screw are
fully pressing against one another.
- Use the "+" driver (Manual or
motorized) when tightening the
screw.
Wall mount screw
e
Advertisement
