Advertisement
Installation method
- Tools you will need : Phillips head "+" driver(Manual or motorized)
You may also need an 8 mm socket wrench or an Ø8 mm drill bit for concrete.
- The actual product may differ from the picture.
Fixating the mounting bracket on the TV
1
If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and
refer to the technical service manual.
Guide spacer
How to attach to masonry walls
2
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and
hallow block that do not crack.
Please follow the below direction.
- Check the material of the wall and the thickness of the finishing.
- When installing the product on wall material not designated, install the product so that each fixated location can withstand
the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
b
- Use the Ø8 mm drill bit for concrete and hammer (Impact) drill.
a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm.
4
Guide spacer screw
42LB55/56*/58*/65* Model
Wall mount screws
(TV Accessories)
* Tighten the wall mount screws provided with the TV, the guide spacers, and
the guide spacer screws provided with the wall mount in the order shown
in the picture.
* Only insert the wall mount screws into the two holes near the
top of the TV and then tighten the screws.
Anchor
c
Ø4 mm drill bit for wood or steel / Level / Stud finder / Drill.
<Work procedure>
1. Check to see if the display has
Guide spacer screw
2. Assemble the guide spacer and
Guide spacer
e
d
screws installed into the mounting
holes. If so, remove those.
the guide spacer screw in order as
shown in the picture.
- Assemble the guide spacer to the
set by tightening the screw.
- Tighten the screw until the set,
guide spacer and the screw are
fully pressing against one another.
- Use the "+" driver (Manual or
motorized) when tightening the
screw.
Wall mount screw
Advertisement
