Advertisement
Installation method
- Tools you will need : Phillips head "+" driver(Manual or motorized)
You may also need an 8 mm socket wrench or an Ø8 mm drill bit for concrete.
- The actual product may differ from the picture.
Attach the mounting bracket to the TV
1
If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and
refer to the technical service manual.
Guide spacer
How to attach to masonry walls
2
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and
hallow block that do not crack.
Please follow the below direction.
- Check the material and thickness of the wall.
- When installing the product on wall material not designated, install the product so that each fixated location can withstand a
pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
a
b
- Use the Ø8 mm drill bit for concrete and hammer (Impact) drill. z
a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor into the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e. Align the wall mount bolts to the holes and tighten them by hand. Then, fasten the bolts at a torque of 45 kgf/cm - 60 kgf/cm.
4
Ø4 mm drill bit for wood or steel / Level / Stud finder / Drill.
<Work procedure>
1. Check to see if the display has screws installed into the
Guide spacer
mounting holes. If so, remove those.
screw
2. Assemble the guide spacer and the guide spacer screw in
order as shown in the picture.
- Assemble the guide spacer to the set by tightening the
screws.
- Tighten the screw until the set, guide spacer and the screw
are fully pressing against one another.
- Use a Phillips Head driver (Manual or motorized) when
tightening the screws.
Anchor
c
d
Wall mount screw
e
Advertisement
