Advertisement
Installation method
- Tools you will need : Phillips head "+" driver(Manual or motorized)
Stud finder / Drill. You may also need an 8 mm socket wrench or an Ø8 mm drill bit for concrete.
1
Separating the TV bracket
Safety pin
<Work procedure>
1. After expanding the wall mount forward as shown in Fig. 1, separate the safety pin from the wall mount as
shown in Fig. 2.
2. Separate the set bracket as shown in Fig. 3.
Attaching the mounting bracket on the TV
2
Make sure the screws are fully tightened to the bracket and display. If the screws will not fully tightened, they
might be too long or the wrong size.
VESA 75X75 / VESA 100X100 / VESA 200X100 is supported.
If needed, you may refer to the display's user manual to verify the display has one of the supported VESA formats.
<Work procedure>
1. Check to see if the display has screws already installed into the VESA mounting holes. If so, remove those.
2. Attach the bracket to the back of the display as shown above. Use a Phillips head "+" screwdriver to tighten the
screws.
- At this time, be careful to prevent the set from falling down.
- Make sure the screws are fully tightened to the bracket and display.
4
1
2
Ø4 mm drill bit for wood or steel / Level /
3
Bracket to attach to
the display
Advertisement
