System Functions; When Your Security System Is Triggered - Code Alarm GUARDIAN CPL 100 Owner's Manual

System Functions

Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the LOCK button on your keyless entry
remote control. The system will flash the parking lights 2 times, indicating the system is armed, and
activated the starter disable feature. The status indicator (red warning light) will blink steadily, once per
second.
Pre-arm Mode
If the system sounds 1 time and the parking lights flash only 1 time, this indicates that the vehicle's
interior light is on or an entrance is left open. Check to see that all doors hood and trunk are closed
properly. Once all entrances are secured (and the interior light is off), this system will sound/flash
again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will
arm and ignore the unsecured entrance until it is closed.)
Disarming the Security System
To disarm the system press the UNLOCK button. The system will flash the parking lights 1 time.
Using Valet Mode
To engage valet mode:
1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF.
2. The red LED will flash 2 times quickly then pause indicating that the system is in
valet mode.
When valet mode is activated all security functions will be disabled.
To disengage valet mode:
1. Turn the ignition key ON/OFF, ON/OFF, ON/OFF.
2. The red LED will turn off indicating that the system has exited valet mode.

When Your Security System is Triggered

The CPL Security System will trigger if one of the following events occurs while the system is armed:
•
Any protected entrance is opened.
•
The vehicle ignition is turned on.
•
The vehicle is jolted hard enough to signal the impact sensor.
Once the alarm is triggered, the horn will sound and the vehicles parking lights will flash for 30 seconds.
The system will then re-arm, awaiting the next intrusion attempt.
4