Table of Contents
Advertisement
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
bag
Screw two housing assembly screws from the
hardware bag halfway into the upper switch
housing. It does not matter which two screw
holes you choose.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Ceiling Bracket
Hanging Fan
Assembling the Light Kit
2 of 6
Light Kit Screw
bag
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
2 of 6
Light Kit Screw
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.Wrap light
kit keyhole slots around the screws and twist
counterclockwise.
Installing the Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Wiring
Blades
Insert the third screw, found in the
hardware bag, into place and then
tighten all three screws.
Insert the third screw, found in the bag of
materials, into place and tighten the three
screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Remote
1886
1 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
8
Trouble Shooting
Advertisement
Table of Contents
