Related Manuals for Hunter 51059
Summary of Contents for Hunter 51059
- Page 1 Low Profile Installation Manual Model: 51059 White 51060 Antique Pewte 51061 New Bronze 51062 Antique Brass 52392 Flat Matte Black Fan weight ±2 lbs: 11.9 lbs (5.4 kg) ©2022 Hunter Fan Co. PG4084 r080822...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
Drill 9/64” fan-rated outlet box. Make Hunter Pro Tip: pilot holes in support structure sure it is securely installed to aid in securing ceiling bracket and is acceptable for fan... - Page 5 1886 Wiring the Fan We know wiring is hard. Let’s make it easier. Hunter Pro Tip: Follow these steps to get your fan wired quickly and safely. Follow the route be- Here is how to connect the wires: low that best matches your wall switch setup. If you are unfamiliar with wiring or Push the bare metal ends of the wires together and slide a wire nut over them.
-
Page 6: Installing The Motor Housing
1886 Installing the Motor Housing Notch Motor Housing Screw Indentation Raise the motor housing up over the motor and ceiling bracket. Turn the motor housing so the screw holes align With a Phillips head screwdriver, install and the indentation in the housing locks into place with the four motor housing screws found in the notch in the ceiling bracket. - Page 7 1886 Assembling Switch Housing 2 of 6 1 of 6 Light Kit Screw Light Kit Screw Insert a third screw, found in the Feed the wire plug through the center hardware bag, into place and hole of the upper switch housing, then tighten all three screws.
-
Page 8: Troubleshooting
• Check to see if any of the blades are cracked. If so, • Check the plug connection in the switch housing. replace all of the blades. Hunter Pro Tip: Cleaning the Fan Use soft brushes or cloths to prevent scratching. -
Page 9: Limited Lifetime Warranty
WARRANTY, BREACH OF CONTRACT, OR OTHERWISE. Some States do not allow the Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. exclusion or limitation of incidental or consequential damages, so the above limitation or What Does This Warranty Cover? exclusion may not apply to you.