Table of Contents
Advertisement
Safety Notes
■
ALWAYS:
♦
Connect to a grounded circuit.
♦
Connect to operating voltages as specified on the product's spec sticker.
♦
Disconnect from power before replacing the fuse.
♦
Disconnect from its power source during periods of inactivity.
♦
Use a safety cable when suspending overhead.
♦
Heed all restrictions and warnings on the spec sticker.
♦
Mount in a location with at least 20 in (50 cm) of ventilation.
♦
Replace the fuse with the same type and rating.
♦
Use a clamp with a captive bolt when a single hanging bracket is used.
■
In the event of a serious operating problem, stop using immediately.
■
DO NOT:
♦
Open this product or attempt any repairs. It contains no user-serviceable parts.
♦
Look at the light source when the product is on.
♦
Use if the power cord is crimped or damaged.
♦
Disconnect by pulling on the power cord.
♦
Allow flammable materials close to the product when it is operating.
♦
Touch the housing when it is on.
♦
Block any ventilation holes/slots in the housing.
♦
Connect to a dimmer or rheostat.
♦
Carry the product by its power cord.
♦
Operate in temperatures higher than 104°F (40°C).
♦
Expose to environments that exceed the Ingress Protection (IP) rating.
♦
Expose to rain or moisture.
♦
Use outdoors.
♦
Submerge.
♦
Leave outdoors for extended periods of time.
♦
Expose to corrosive environmental conditions such as temperature, humidity, salinity,
pressure, radiation, or shock.
♦
Set this product on a flammable surface.
FCC Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 cm between
the radiator and your body. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter
Keep this User Manual for future use. If the product is sold to someone else, be sure that they
also receive this document.
2
Before You Begin
EZLink Strip Q6BT ILS User Manual Rev. 1
Advertisement
Table of Contents
