Safety Notes - Chauvet DJ GigBAR MOVE + ILS Quick Reference Manual

EN

Safety Notes

These Safety Notes include important information about installation, use, and maintenance of the GigBAR MOVE + ILS.
■ The luminaire is intended for professional use only.
■ The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
20.7 ft (6.3 m) is not expected.
■ If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or its service agent.
■ The light source contained in this luminaire shall only be replaced by the manufacturer or its service agent or
a similar qualified person.
■ ALWAYS:
♦ Connect to a grounded circuit.
♦ Connect to operating voltages as specified on the product's spec sticker.
♦ Disconnect from power before replacing the fuse.
♦ Disconnect from its power source during periods of inactivity.
♦ Use a safety cable when suspending overhead.
♦ Heed all restrictions and warnings on the spec sticker.
♦ Mount in a location with at least 20 in (50 cm) of ventilation.
♦ Replace the fuse with the same type and rating.
■ In the event of a serious operating problem, stop using immediately.
■ DO NOT:
♦ Open this product or attempt any repairs. It contains no user-serviceable parts.
♦ Look at the light source when the product is on.
♦ Use if the power cord is crimped or damaged.
♦ Disconnect by pulling on the power cord.
♦ Allow flammable materials close to the product when it is operating.
♦ Touch the housing when it is on.
♦ Block any ventilation holes/slots in the housing.
♦ Connect to a dimmer or rheostat.
♦ Carry the product by its power cord.
♦ Operate in temperatures higher than 104°F (40°C).
♦ Expose to environments that exceed the Ingress Protection (IP) rating.
♦ Expose to rain or moisture.
♦ Use outdoors.
♦ Submerge.
♦ Leave outdoors for extended periods of time.
♦ Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation,
or shock.
♦ Set this product on a flammable surface.
1
QUICK REFERENCE GUIDE
GigBAR MOVE + ILS QRG Rev. 2