Table of Contents
Advertisement
3. Setup
AC Power
The EZLink Strip Q6BT ILS has an auto-ranging power supply, and it can work with an input voltage range
of 100 to 240 VAC, 50/60 Hz. To determine the product's power requirements (circuit breaker, power outlet,
and wiring), use the current value listed on the label affixed to the product's back panel, or refer to the
product's specifications chart. The listed current rating indicates the product's average current draw under
normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse Replacement
1.
Disconnect the product from power.
2.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3.
Pry the safety cap out of the housing.
4.
Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the
exact same type and rating.
5.
Re-insert the fuse holder and reconnect power.
Battery Power
The EZLink Strip Q6BT ILS comes with a rechargeable lithium battery for cable-free operation.
Charging the Battery
The battery charges whenever the EZLink Strip Q6BT ILS is plugged into a power source using the
included power cord. If the product is plugged in and not in operation, make sure the product is turned off.
•
The LED indicator light will flash if units are overcharged.
•
DO NOT use the EZLink Strip Q6BT ILS on full power mode (all LEDs at 100%)
while being charged/plugged into a power source, as the unit will get extremely
hot.
Battery Life Indicator
The indicators on the LED Menu Display show how much battery life remains available. The drawing below
provides a key to reading the battery life indicators.
100%
Battery Run Time
Maximum Run Time
(all colors on)
Up to 8 hours
4
75%
50%
Maximum Run Time
(single color on)
Up to 20 hours
EZLink Strip Q6BT ILS User Manual Rev. 1
Setup
25%
Recharge Time
4 hours
Advertisement
Table of Contents
