Table of Contents
Advertisement
ASSEMBLY
INSTALLING WHEELS AND FEET
BEFORE ASSEMBLING THE
GENERATOR, REVIEW THE SAFETY
SECTION.
CAUTION
Never lift the generator without
assistance. The generator is heavy and
lifting without assistance could result in
personal injury.
Never use the handles as a lifting point
to support the entire weight of the
generator. Only use the handles to move
the generator by lifting the handles and
using the wheels to move the generator.
Use caution when collapsing the
handles. Hands and fingers could get
caught and pinched.
NOTICE
Assembling the generator will require lifting the unit
on one side. Make sure all engine oil and fuel are
drained from the unit prior to assembling. Once
assembled, the wheel kit is not intended for on-
road use. The wheel kit is designed for use on this
generator only.
INSTALLING FEET TO FRAME
1. Place generator on a flat surface.
2. Place a piece of cardboard or other soft material to
tip the generator onto, to protect the frame paint and
prevent the generator from sliding. Tip the generator
onto the side.
3. Install the mounting foot (5) to the frame using M8
flange bolts (2).
2
Figure 1 - Assemble Mounting Feet to Frame
5
INSTALLING WHEELS TO FRAME
1. Insert axle pin (4) through wheel (6) and place washer
(1) between wheel and mounting bracket.
Mounting
bracket
Figure 2 -Wheel Assembly
2. Place hairpin cotter pin (3) through the eye of the wheel
axle pin (4) to secure wheel.
3. Repeat previous steps on other wheel.
CONNECTING THE BATTERY
To avoid electric shock:
• ALWAYS connect the positive (+) battery cable (red
boot) first when connecting battery cables.
• ALWAYS disconnect the negative (-) battery cable
(black boot) first when disconnecting battery cables.
• NEVER connect the negative (-) battery cable (black
boot) to the positive (+) post on the battery.
• NEVER connect the positive (+) battery cable (red
boot) to the negative (-) post on the battery.
• NEVER touch both battery posts simultaneously.
• NEVER place a metal tool across both battery posts.
• ALWAYS use insulated or nonconducting tools when
installing the battery.
1. Verify the positive (+) battery cable (red boot) is securely
tightened to the positive (+) battery post. Make sure
boot is over battery post.
2. Verify the negative (-) battery cable (black boot) is
securely tightened to the negative (-) battery post. Make
sure boot is over battery post.
3. Connect the battery quick connect leads (see image
below).
Figure 3 - Connect battery
The electric start generator is equipped with a battery charging feature.
Once the engine is running, a small charge is supplied to the battery
via the battery cables and will slowly recharge the battery.
Westinghouse Outdoor Power Equipment, LLC | 11
3
1
6
WARNING
NOTICE
4
Advertisement
Table of Contents
