Fluke 1736/FPC User Manual page 74

Hide thumbs

Table Of Contents

Table of Contents

Auxiliary Inputs

Wired Connection

Number of Inputs.............................................2

Input Range.....................................................0 V dc to ± 10 V dc

Wireless Connection (requires WiFi/BLE adapter USB1 FC)

Number of Inputs.............................................2

Supported Modules .........................................Fluke Connect 3000 series

Acquisition...........................................................1 reading/s

Scale factor .........................................................Format: mx + b (Gain and offset) user configurable

Displayed units....................................................User configurable (up to 8 characters, for example °C, psi, or m/s)

Data Acquisition

Resolution ...........................................................16-bit synchronous sampling

Sampling Frequency ...........................................10.24 kHz at 50/60 Hz, synchronized to mains frequency

Input Signal Frequency .......................................50/60 Hz (42.5 Hz to 69 Hz)

Wiring Configurations..........................................1-Φ, 1-Φ IT, Split phase, 3-Φ wye, 3-Φ wye IT, 3-Φ wye balanced, 3-Φ delta, 3-Φ Aron/Blondel (2-element

Data Storage .......................................................Internal flash memory (not user replaceable)

Memory Size .......................................................Typical 10 logging sessions of 8 weeks with 1-minute intervals and 100 events The number of possible

Basic Interval

Measured Parameter ..........................................Voltage, Current, Aux, Frequency, THD V, THD A, Power, Power Factor, fundamental Power, DPF, Energy

Averaging Interval ...............................................User selectable: 1 sec, 5 sec, 10 sec, 30 sec, 1 min, 5 min, 10 min, 15 min, 30 min

Total Harmonic Distortion....................................THD for voltage and current is calculated on 25 harmonics

Averaging time min/max values

Voltage ............................................................Full cycle RMS (20 ms at 50 Hz, 16.7 ms at 60 Hz)

Current ............................................................Half cycle RMS (10 ms at 50 Hz, 8.3 ms at 60 Hz)

Aux, Power......................................................200 ms

Demand Interval (Energy Meter Mode)

Measured Parameter ..........................................Energy (Wh, varh, VAh), PF, Maximum Demand, Cost of Energy

Averaging Interval ...............................................User selectable: 5 min, 10 min, 15 min, 20 min, 30 min, off

1.800.561.8187

delta), 3-Φ delta open leg, 3-Φ high leg delta, 3-Φ delta balanced. Currents only (load studies)

logging sessions and logging period depends on user requirements.