LG A9T Series Owner's Manual page 28

OPERATION
28
When using the steam mode, a constant amount of
water is supplied regardless of the operation of the
water adjustment buttons.
• High Mode: Press the High Mode button
the way down to clean ingrained dirt or supply a
large amount of water.
• Low Mode: Press the Low Mode button
way down to supply a small amount of water for
cleaning wood or other flooring that can be
damaged by too much water.
• STOP: Press the Low Mode or High Mode
button halfway to toggle back to the STOP
position. This stops the supply of water so you
can go over areas that are already wet.
Using with the Steam Mop Nozzle
• When using the steam mode, a constant amount
of water is supplied regardless of the operation
of the water adjustment buttons.
• Insert the water tank filled with water into the
steam mop nozzle, attach the mop pads soaked
in water, and then insert the battery pocket.
1
Insert the battery pocket
mop nozzle , and insert the fully charged
c
spare battery into the battery pocket
a
Push the battery pocket and the battery all the
way in until a click is heard.
all
a
all the
b
into the steam
b
.
b
2
Insert the steam mop nozzle into the extension
pipe and connect it to the product body. When
you press the Power button
body, the steam mode will be turned on and
preheating will begin.
• During preheating, the nozzle front LED will
blink.
• When you turn on steam mode, the steam
generator will be preheated for about 40
seconds and then steam will be sprayed.
Begin cleaning when the red battery pocket
LED turns on. It's normal for steam to not be
emitted from the mop pads as the steam can
be dissipated by the floor or the pads.
• After steam is sprayed, it takes about 80
seconds for the mop pads to be heated to
about 60 \ .
Charging the Battery and Storing
the Steam Mop Nozzle
1
When cleaning is finished, press the Power
button on the product body to turn the product
off.
2
The battery pocket does not have a charging
function. Separate the battery from the battery
on the product
d