Table of Contents
Advertisement
Steps
1. Remove the single screw (M2x4) that secures the M.2 2230 solid-state drive to the system board .
2. Slide and remove the M.2 2230 solid-state drive from the solid-state drive slot on the system board.
Installing the 2230 solid-state drive—SSD1 slot
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Solid-state drives are fragile. Exercise care when handling the solid-state drive.
NOTE:
Depending on the configuration ordered, your computer may support a 2230 solid-state drive, or a 2280 solid-state
drive in M.2 slot.
NOTE:
This procedure applies only if you are installing a 2230 solid-state drive in M.2 slot.
The following images indicate the location of the 2230 solid-state drive that is installed in M.2 slot and provides a visual
representation of the installation procedure.
28
Removing and installing components
Advertisement
Table of Contents
