Installation Of The Oven Feet; Control Panel - Teka FS 903 5VE SS User Manual

EN

Installation Of The Oven Feet

In order to install the oven feet;
1. Foot attachment lath is installed on the oven from the bottom of the
oven as shown in (figure 1).Nuts are centered on these lathes in order to
screw feet. Complete the feet installation process by screwing the feet to
the nuts (figure 2).
2. You can balance your oven by turning the screwed feet according to
the surface type you are using.
3. If your oven has plastic food as in (figure 3) you can adjust your ovens
height from these feet as turned clockwise or anticlockwise.
Figure 1

CONTROL PANEL

1 2
1. Thermostat
2. Function selection button
3. Front left ceramic heater
4. Rear left ceramic heater
WARNING: The control panel above is only for illustration purposes.
Consider the control panel on your device.
Figure 2
3 4
5. Center ceramic heater
(ovaldual)
6. Rear right ceramic heater
7. Front right ceramic heater
20
Figure 3
5 6 7