Hints And Tips; Selection Of Installation Equipment; Technical Specification - Candy CEHDD30TCT/1 Instruction Manual

Hints and Tips

Problem Possible causes
The cooktop cannot No power.
Be turned on.
The touch controls are The controls are locked.
unresponsive.
The touch controls are There may be a slight film of
difficult to operate. water over the controls or you
may be using the tip of your
finger when touching the
controls.
The glass is being Rough- edged cookware.
scratched.
Unsuitable, abrasive scourer or
cleaning products being used.
Some pans make
This may be caused by the
crackling or clicking construction of your cookware
noises. (layers of different metals
vibrating differently).

Technical Specification

Cooking Hob
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size L×W×H(mm)
Built-in Dimensions A×B (mm)
Weight and Dimensions are approximate. Because we continually strive to
What to do
Make sure the cooktop is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If
you've checked everything and the
problem persists, call a qualified
technician.
Unlock the controls. See section
'Using your ceramic cooktop' for
instructions.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
Use cookware with flat and smooth
bases. See 'Choosing the right
cookware'.
See 'Care and cleaning'.
This is normal for cookware and
does not indicate a fault.
CEHDD30TCT/1
2 Zones
220-240V~, 50-
2928- 3484W
288X520X52
268X500
EN-15
improve our products we may change specifications and designs without prior
notice.
Installation

Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by
the heat radiation from the hotplate. As shown below:
A(mm)
268
＋4
-0
Under any circumstances, make sure the ceramic cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in
good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760mm.
60Hz
B(mm) C(mm) D(mm)
500
＋4
50mini 50 mini
-0
EN-16
E(mm) F(mm)
50 mini 50 mini