Daikin FTX30WVJU9 Operation Manual page 31

„ Titanium apatite photocatalytic air-purifying filter
1.
Open the front panel and
pull out the air filters.
2.
Take off the titanium apatite
photocatalytic air-purifying
filters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
3.
Clean or replace the
titanium apatite
photocatalytic air-purifying
filters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to 15
minutes if very dirty.
• Do not remove the filter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the filter to remove water from it.
[Replacement]
Remove the filter from the filter
Page 28, 29
frame and attach a new one.
• Do not throw away the filter frame. Reuse the filter
frame when replacing the titanium apatite
photocatalytic air-purifying filter.
• When attaching the filter, check that the filter is
properly set in the tabs.
• Dispose of the old filter as non-flammable waste.
4.
Set the titanium apatite
photocatalytic air-purifying
filters as they were.
5.
Set the air filters as they
were.
6.
Close the front panel slowly.
NOTE
• Operation with dirty filters:
– cannot deodorize the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odor.
• Dispose of old filters as non-flammable waste.
• To order a titanium apatite photocatalytic air-purifying
filter, contact the dealer where you bought the air
conditioner.
Item
Part No.
Tabs
Titanium apatite photocatalytic
air-purifying filter (set of 3)
KAF970A48 (without frame)
Care
Page 29
Page 28
30