Hubsan H123D X4 JET Quick Start Manual page 4

16. Noncompliance
guidelines/methods given through official Hubsan website announcements, product quick
start guides, user manuals, etc.
17. Other losses, damages, or injuries that are not within the boundaries of Hubsan
responsibility.
说 明
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE LOCAL REGULATIONS.
HAZARDOUS MOVING PARTS KEEP FINGERS AND OTHER BODY PARTS AWAY.
Declaration of Conformity
Hereby, SHENZHEN HUBSAN TECHNOLOGY CO., LTD.,
declares this product is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. A copy of the original Declaration of Conformity can
be obtained at the following address: 13th Floor, Bldg 1C, SHENZHEN NANSHAN
SOFTWARE INDUSTRY BASE, Xuefu Road, Nanshan District, Shenzhen, China
This product bears the selective sorting symbol for waste electrical and electronic
equipment (WEEE). This means that this product must be handled pursuant to European
Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the
environment.
For further information, please contact your local or regional authorities. Electronic
products not included in the selective sorting process are potentially dangerous for the
environment and human health due to the presence of hazardous substances.
FC C IN F O R MA T IO N
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged totry to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
with precautions, instructions, information and operation