Table of Contents
Advertisement
3.
Remove the battery (see
Remove the touchpad:
1.
Remove the protective Mylar from the top of the touchpad (1).
2.
Disconnect the two cables from the ZIF connectors on the touchpad cable (2), and then peel the cables
off the touchpad. The cables are secured to the touchpad with adhesive.
3.
Remove the 12 Phillips M2.0 × 2.0 screws (3) that secure the touchpad to the computer.
4.
Lift the touchpad straight up to remove it (4).
To install the touchpad, reverse this procedure.
WWAN module
To remove the WWAN module, use this procedure and illustration.
Table 5-4
WWAN module descriptions and part numbers
Description
Intel 5000 5G Solution WWAN
Bracket
Intel XMM 7360 LTE-Advanced WWAN (Cat 9)
Bracket
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WWAN module, follow these steps:
1.
Prepare the computer for disassembly (see
30
Chapter 5 Removal and replacement procedures for authorized service provider parts
Battery on page
To prevent an unresponsive system, replace the wireless module only with a wireless module
27).
Preparation for disassembly on page
Spare part number
N13456-001
N13438-001
N13457-001
N13439-001
26).
Advertisement
Table of Contents
