Advertisement
CLEANING
Always unplug the kettle from the
mains supply socket and allow it to
completely cool down before cleaning
or descaling it. Do not immerse the
kettle, power base or power cord and
plug in water or any other liquid.
1. Clean the exterior surface of the kettle
with a damp cloth and then polish with
a soft dry cloth. Do not use steel wool
pads or harsh/abrasive cleaners.
2. Descale your kettle regularly to keep
it working efficiently. Use a proprietary
descaling product following the
manufacturer's instructions carefully.
CLEANING THE FILTER
Before removing or refitting the
filter, switch off the kettle and empty it.
Allow it to cool completely, then unplug
the power base from the mains supply
socket. Never operate the kettle without
the filter fitted.
•
Open the lid and remove the filter from
behind the spout.
•
Rinse the filter under a tap whilst
brushing it with a soft brush.
•
In hard water areas it may be
necessary to descale the filter using a
descaling product. Use a proprietary
descaling product following the
manufacturer's instructions carefully.
•
The filter may be washed safely in the
cutlery rack of a dishwasher.
•
Refit the filter back into your kettle.
TROUBLESHOOTING
For troubleshooting and FAQs visit:
www.breville.co.uk/faqs
6
ELECTRICAL SAFETY
This appliance must be earthed.
If the plug is not suitable for the socket
outlets in your home, it can be removed
and replaced by a plug of the correct type.
If the fuse in a moulded plug needs to be
changed, the fuse cover must be refitted.
The appliance must not be used without
the fuse cover fitted.
If the plug is unsuitable, it should be
dismantled and removed from the supply
cord and an appropriate plug fitted as
detailed. If you remove the plug it must not
be connected to a 13 amp socket and the
plug must be disposed of immediately.
If the plug fuse requires replacement, a
fuse of the same rating as that fitted by
the manufacturer must be used. In order
to prevent a hazard do not fit a fuse of a
lower or higher rating.
Ensure that the outer sheath of the cable
is firmly held by the clamp
AFTER SALES SERVICE &
REPLACEMENT PARTS
In the case the appliance does not
operate but is under warranty, return the
product to the place it was purchased for a
replacement. Please be aware that a valid
form of proof of purchase will be required.
For additional support, please contact our
Consumer Service Department at 0800
028 7154 or email:
BrevilleEurope@newellco.com.
Advertisement
