Advertisement
BEFORE FIRST USE
Remove any packaging and promotional
material from your kettle and position it on
a stable, secure, dry and level work surface
away from the edge.
Before connecting to a power source,
make sure your mains supply voltage
is the same as the one indicated on the
appliance. Connect the plug to a suitable
power outlet and make sure that the power
cord does not overhang the work surface.
Excess power cord can be stored in the
power base.
Remove the kettle from the power base
and open the lid. Fill your kettle to the
maximum mark and close the lid.
Place your kettle back onto the power
base. Switch your kettle on, allow it to boil
then discard the water. Repeat twice. This
will remove any residue left over from the
manufacturing process.
USING YOUR KETTLE
If this kettle is filled above the
maximum level mark, hot water may be
ejected from the spout during boiling.
Beware of steam coming from the spout
or lid especially during refilling. Never
open the lid when the kettle is boiling.
1. Plug the power base into a suitable
power outlet. NOTE: The kettle will turn
on and enter stand by mode until one of
the buttons on the base unit is pressed.
2. Remove your kettle from the power
base before filling it with water.
3. Fill your kettle with water. You can
fill it through the spout or by opening
the lid. Don't overfill your kettle and
always ensure that there is sufficient
water in your kettle for it to operate
correctly. This is approximately 250ml
or 1 teacup full. Always check the water
level when your kettle is positioned on
its power base.
4. If opened previously, close the lid and
place your kettle back on the base.
5. The temperature touch pad on the base
4
unit of the kettle allows you to select
your required temperature of water for
the beverage you are making. Choose
your desired temperature by touching
one of the temperature buttons; the
selected temperture will illuminate and
heating will start.
6. The countdown timer on the base of the
unit will indicate the time left until your
kettle reaches the desired temperature.
The length of time the water takes to
get to temperature will vary depending
on the volume of water in the kettle
and the temperature selected. NOTE:
If the selected temperature is changed
during heating the lights and timer on
the base unit will automatically adjust
themselves. NOTE: Due to the variable
way in which heat energy transfers
through water the timer lights may not
extinguish at a steady rate. This is
normal and has no effect on the water
temperature.
7. When your kettle is heating, the
stop button, water level window and
selected temperature will illuminate.
NOTE: During heating the temperature
of the water will be indicated by the
illuminated temperature button. As the
temperature increases the buttons will
illuminate one by one
8. When the water reaches the selected
temperature, your kettle will play a
short tune and the illumination will
flash to indicate the water is ready.
(You have the option to mute the tune
feature if you wish)
9. Heating will switch off automatically
after reaching temperature, or if the
kettle is removed from the base during
heating
10. You may also switch your kettle off
manually at any time by pressing the
stop button again.
11. When the kettle is on the base it
will continue to monitor the water
temperature after the selected
Advertisement
