Advertisement
CLEANING
Always unplug the kettle from the mains
supply socket and allow it to completely cool
down before cleaning or descaling it. Do not
immerse the kettle, power base or power cord
and plug in water or any other liquid.
1. Clean the exterior surface of the kettle with a
damp cloth and then polish with a soft dry cloth.
Do not use steel wool pads or harsh/abrasive
cleaners.
2. Descale your kettle regularly to keep it working
efficiently. Use a proprietary descaling product
following the manufacturer's instructions
carefully.
6
VKT192_20EM1 (UK).indd 6-7
VKT192_20EM1 (UK).indd 6-7
CLEANING THE FILTER
Before removing or refitting the filter, switch
off the kettle and empty it. Allow it to cool
completely, then unplug the power base from the
mains supply socket. Never operate the kettle
without the filter fitted.
• Open the lid and remove the filter from behind
the spout.
• Rinse the filter under a tap whilst brushing it with
a soft brush.
• In hard water areas it may be necessary to
descale the filter using a descaling product. Use
a proprietary descaling product following the
manufacturer's instructions carefully.
• The filter may be washed safely in the cutlery
rack of a dishwasher.
• Refit the filter back into your kettle.
AFTER SALES SERVICE & REPLACEMENT
PARTS
In the case the appliance does not operate but is
under warranty, return the product to the place it was
purchased for a replacement. Please be aware that
a valid form of proof of purchase will be required.
For additional support, please contact our Consumer
Service Department at 0800 028 7154 or email:
BrevilleEurope@newellco.com
TROUBLESHOOTING
For troubleshooting and FAQs visit:
www.breville.co.uk/faqs
ELECTRICAL SAFETY
This appliance must be earthed.
If the plug is not suitable for the socket outlets in
your home, it can be removed and replaced by a
plug of the correct type.
If the fuse in a moulded plug needs to be changed,
the fuse cover must be refitted. The appliance must
not be used without the fuse cover fitted.
If the plug fuse requires replacement, a fuse of the
same rating as that fitted by the manufacturer must
be used. In order to prevent a hazard do not fit a
fuse of a lower or higher rating.
If the terminals in the plug are not marked or if you
are unsure about the installation of the plug please
contact a qualified electrician.
Plug should be ASTA approved to BS1363
Fuse should be ASTA approved to BS1362
Green/Yellow
(Earth)
Blue
(Neutral)
Brown
(Live)
Ensure that the outer sheath of
the cable is firmly held by the cord grip
Waste Disposal
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. E-mail us at BrevilleEurope@newellco.com for
further recycling and WEEE information.
7
7/30/20 09:00
7/30/20 09:00
Advertisement
