Table of Contents
Advertisement
1886
1
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
Insert grommets found in the
holes in the blades, then secure each blade to a blade arm
with screws found in the
hardware bag.
Repeat x5
5
Ceiling Bracket
Installing the Motor Housing
Notch
Indentation
Installing the Blades:
hardware bag into the
Hanging Fan
2
With a Phillips head screwdriver, install
the four motor housing screws found in
the
hardware bag. Tighten all four
screws securely.
Note:
Fan style may vary.
Lightly attach the blade arms to the
motor with the blade arm screws,
then securely tighten after both
screws are attached.
Wiring
Motor Housing
bag
Note:
Fan style may vary.
bag
bag
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Blade Arm Screw
bag
Repeat x5
Note:
Fan style may vary.
Blades
x4
Motor Housing
Screw
x15
Blade Screw
x15
Grommet
x10
Light
Advertisement
Table of Contents
