Installing The Motor Housing; Installing The Mounting Plate; Installing The Blades - Hunter Minikin 50953 Installation Manual

1886
Partially install two of the canopy screws into
screw holes on opposite corners of the ceiling
plate as shown. Choose the two screw holes that
are aligned with the hanging slots in the fan body.
Put the blade washers, found in the
blade screws, found in the hardware bag. Then install the blade
screws to secure each blade to a blade iron.
5
Ceiling Bracket

Installing the Motor Housing

Canopy Screw
bag

Installing the Mounting Plate

Installing the Blades:

hardware bag, onto the
Hanging Fan Wiring
2 of 4
Align the hanging slots on both
sides of the fan body with the two
partially installed canopy screws.
Slide the two slots on both sides of
the fan body between the head of
the screws and rotate the fan body
counter clockwise so the screws
hold the fan body firmly in place.
Repeat x4
IMPORTANT
NOTE: Follow the instructions on the blade. Installing
it incorrectly could result in your fan not functioning.
Remove instructional label after installation.
Motor Housing Blades
bag
Install the remaining two
canopy screws by holding the
fan body cover to the ceiling
mounting plate. Tighten all
four screws securely.
WARNING
FAN FALL HAZARD
Make sure to secure the canopy.
bag
There are four holes on the motor. Lift the mounting plate and
align the grommet holes in the mounting plate with the holes
of the motor. It does not matter which hole you choose. Install
the mounting plate screws found in the hardware bag
secure the mounting plate to the fan.
bag
bag
Light Pull Chains
2 of 4
Canopy Screw
x4
Mounting
Plate Screw
to
Note:
Fan style may vary.
x12
Blade Screw
x12
Washer
Note:
Fan style may vary.
Control