Table of Contents
Advertisement
1886
1
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
Insert grommets found in the
hardware bag into the
holes in the blades, then secure each blade to a blade arm
with screws found in the
hardware bag.
Repeat x5
Repeat x5
5
Ceiling Bracket
Installing the Motor Housing
Notch
Indentation
Installing the Blades:
Hanging Fan
Wiring
2
With a Phillips head screwdriver, install
the four motor housing screws found in
the
hardware bag. Tighten all four
screws securely.
Motor Housing
x4
Motor Housing
Screw
bag
x15
Blade Screw
bag
Grommet
bag
x10
bag
Blade Arm Screw
Lightly attach the blade irons to the motor
with screws found in the
hardware
bagc, then securely tighten after both
screws are attached.
Note:
Fan style may vary.
Blades
Switch Housing
x15
Advertisement
Table of Contents
