Indoor Unit Installation - Daikin FTXS15WVJU9 Installation Manual

Indoor Unit Installation

CAUTION
• Do not hit or forcefully push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
A Mounting plate
B Mounting plate fixing screw
M4 × 1" (M4 × 25mm)
Front panel
1-15/16" (50mm)
or more from walls
(on both sides)
Air filters
C Titanium apatite deodorizing
filter (2 pcs)
Filter frame
Titanium apatite
deodorizing filter
Tab
■
English
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
Screw cover (3 pcs)
M
3/16" × 5/8"
(M4 × 16mm)
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screw.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Air filter
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
1-3/16" (30mm)
or more from ceiling
Caulk
pipe hole
gap
with putty.
INTELLIGENT EYE
sensor
Service lid
D
Wireless
remote
controller
Remote controller
F
holder fixing screw
M3 × 13/16" (M3 × 20mm)
Front grille
Mark (rear side)
Do not connect
commercially available
drain hose directly to the
indoor unit. (Water leakage
may result)
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that no
gap is left in the insulation
pipe's cut line.
Wrap the thermal insulation
pipe with the finishing tape
from bottom to top.
Before screwing the remote
controller holder to the wall,
make sure that control
signals are properly
received by indoor unit.
E
Remote
controller holder
A Mounting
plate
Clip
Bottom frame
4