Table of Contents
Advertisement
Installation
24
English
FULL_DW60BB890UAPET_DD68-00254C-00_EN.indd 24
3. When both sides of the panel lock into
place, press the top center of the custom
panel to secure it to the top of the door.
NOTE
• Make sure that the custom panel fits in
the dishwasher properly.
• If the gap between the dishwasher and
the custom panel is below 2 mm, proper
installation is done. For 2 mm or more,
remove the custom panel and try again.
4. Unpack the caps and screws (two for
each) included in the product package.
5. Tighten the screws on either side of the
dishwasher.
NOTE
When tightening the screw on either side,
make sure to check the gap between either
side as the custom door may lean in either
side.
6. Insert the caps on either side. Make sure
the rib of the cap fits in the hole of the
dishwasher in the right direction.
2023-03-09
6:27:35
Advertisement
Table of Contents
