Table of Contents
Advertisement
Unboxing the DM5500 and removing the shipping
screws
Steps
1. Place the DM5500 shipping box on sturdy table.
WARNING:
Do not attempt to lift the system by yourself to avoid potential injury. The DM5500 shipping box
requires two people to lift it onto a table. The maximum weight of the DM5500 with all 24 drives installed is
43.2 kg (95.24 lb).
2. Open the top of the box and cut all sides of the box open to access the DM5500 chassis.
3. Carefully remove all the contents of the box except for the main chassis.
4. Remove the shipping screws from the sides of the DM5500.
Figure 13. Remove the shipping screws
Removing drives
Prerequisites
Before you
install the DM5500 into the
weight of the system.
CAUTION:
When removing drives, it is very important to label each drive with its slot number so you can put
each drive back into its correct position once the DM5500 is installed in the rack. If you do not put the drives
rack, you must remove all drives and
power supply units
from the DM5500 due to the
Install the DM5500 in the rack
23
Advertisement
Table of Contents
