Advertisement
Quick Links
Installation Instructions
Dummy Rail
PE8893 & PE8895 Exit Devices
WARNING
This product can expose you to
lead which is known to the state of
California to cause cancer and birth
defects or other reproductive harm.
For more information go to www.
P65warnings.ca.gov.
1-800-727-5477 • www.sargentlock.com
Copyright © 2023, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
WARNING
Attention Installer: Improper
installation may result in damage
to the product and void the factory
warranty.
A8320-1 5/23
Advertisement
Related Manuals for Assa Abloy Sargent PE8893
Summary of Contents for Assa Abloy Sargent PE8893
- Page 1 Installation Instructions Dummy Rail PE8893 & PE8895 Exit Devices WARNING WARNING This product can expose you to Attention Installer: Improper lead which is known to the state of installation may result in damage California to cause cancer and birth to the product and void the factory defects or other reproductive harm.
-
Page 2: Installation Instructions
Dummy Rail PE8893 Exit Device Installation Instructions Screw Chart TOTAL QTY DESCRIPTION WHERE USED SUPPLIED (4) CHASSIS CORNER MOUNTING HOLES #10-24 X 3/4" FLAT HEAD (METAL DOOR) MACHINE SCREW (4) CHASSIS CORNER MOUNTING HOLES (WOOD DOOR) #10 X 1-1/4" FLAT HEAD WOOD SCREW (2) REAR MOUNTING PLATE (METAL DOOR) - Page 3 Dummy Rail PE8893 Exit Device Installation Instructions Measure 39-5/8” from the finished floor and mark Using a square, create a horizontal and vertical door and frame centerline. Vertical centerline should be 2-3/4” off of the edge of the door or centered on the door stile. A8320-1 5/23 1-800-727-5477 •...
- Page 4 Dummy Rail PE8893 Exit Device Installation Instructions 4X 10-24 THREADED HOLES Align supplied plastic template with the centerlines. Prepare chassis mounting holes. Refer to supplied Mark chassis mounting holes. trim template as needed. 4X 10-24 X3/4" FLAT HEAD SCREWS Slide rail assembly onto the chassis. Install chassis using supplied mounting screws 10-24 x 3/4”.
- Page 5 Dummy Rail PE8893 Exit Device Installation Instructions carrier tab Ensure rail carrier tabs are aligned with the chassis, then fully tighten the chassis screws. Insert the end cap bracket into the rail assembly. Level the rail and mark mounting holds using the bracket as a guide.
- Page 6 Dummy Rail PE8893 Exit Device Installation Instructions Drill and tap end cap bracket holes 10-24 Install end cap bracket using round head Phillips (2 places). 10-24 x 1” screws, supplied. Install chassis and end cap cover using supplied 8-32 x 5/16” oval head screws. A8320-1 5/23 1-800-727-5477 •...
- Page 7 Dummy Rail PE8893 Exit Device Installation Instructions A8320-1 5/23 1-800-727-5477 • www.sargentlock.com Copyright © 2023, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in part without the express written permission of SARGENT Manufacturing Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
- Page 8 1-800-727-5477 • www.sargentlock.com Copyright © 2023, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in part without the express written permission of SARGENT Manufacturing Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents. A8320-1 5/23...