Sealing Cabinet To Floor; Installing The Unit - Perlick HB24 Series Installation & Operation Manual

Single Door Undercounter Refrigeration Installation & Operation Manual
INSTALLING THE CABINET - SINGLE DOOR UNDERCOUNTER CABINETS

Sealing Cabinet to Floor

For units without casters or legs, it may be
necessary to seal the base of the cabinet to
the floor. This can be accomplished by laying a
bead of silicone sealant between the base of the
cabinet and the floor (Figure 1).

Installing the Unit

1). Plug the unit into the 15 amp grounded electrical
outlet located within the installation opening. With
power applied to the unit, check that the lighting and
cooling functions operate properly. Turn off the power
to the wall outlet at the circuit breaker.
2). Slide the unit into position in the opening. Make
sure the rear glides slide under the anti-tip brackets.
Push the unit into the opening until the bottom front
edge of the unit is flush with the surrounding cabinetry,
or until the rear glides are tight against the anti-tip
brackets.
NOTE: The rear glides must be engaged under the
anti-tip brackets.
NOTE: Countertop should be resting evenly on en-
tire top of the unit. Shim if necessary to prevent dam-
age to the countertop.
3). Check interior door openings to make sure the unit
is level and square. Install shelving and/or drawers.
Place the slide brackets squarely into the bracket
grooves. When installed properly, a "click: should be
heard from the slide bracket retaining tabs and the
brackets should slide smoothly. The retaining tabs will
stop the shelf/drawer when pulled out to full extension.
4). Turn the power on to the circuit breaker.
NOTE: Improper shelf/drawer installation may not
actuate slide mechanism.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Cabinet
Bead Silicon
Sealer (RTV)
Floor
Sealing Cabinet to Floor
Leveling the Unit
4