1. Friction disc
2. Pressure plate
Adjusting the
Service/Parking Brake
Adjust the service/parking brake if it slips during
operation.
1.
Disengage the parking brake.
2.
Measure the free play at the end of the
parking-brake handle
The handle free play should be between 12.7 to
25.4 mm (0.50 to 1 inch). If the free play is not
within this amount, proceed to step
the brake cable.
Figure 31
3. Gap—1.1 mm (0.045 inch)
(Figure
32).
3
to adjust
g274479
1. Parking-brake handle
3.
Perform the following steps to adjust the
brake-cable tension:
•
To increase the cable tension, loosen the
front-cable jam nut and tighten the rear jam
nut
(Figure
the tension if necessary.
•
To decrease the cable tension, loosen the
rear jam nut and tighten the front-cable jam
nut
(Figure
the tension if necessary.
27
Figure 32
2. Appropriate free play of
12.7 to 25.4 mm (0.50 to
1 inch).
33). Repeat step
2
and adjust
33). Repeat step
2
and adjust
g373542