Table of Contents
Advertisement
Servicing the Brake Interlock
Switch
1. Turn off the machine and disconnect the battery pack.
2. Remove the console cover.
3. Engage the service brake lever and engage the parking
brake latch.
4. Loosen the interlock switch mounting fasteners
45).
Figure 45
1. Parking brake latch
2. Interlock switch
5. Place a 1.6 mm (0.062 inch) thick shim between the
parking brake latch and the interlock switch
6. Tighten interlock switch mounting fasteners. Check
the gap. The latch must not contact the switch.
7. Engage the brake lever and rotate the latch. Verify
that the switch loses continuity. Replace the switch if
required.
(Figure
g016913
3. Service brake lever
(Figure
Brake Maintenance
Adjusting the Service/Parking
Brake
If the service/parking brake slips when operated, adjust the
cable.
1. Turn off the machine and disconnect the battery pack.
2. Move the service/parking brake lever to the
position.
3. Remove the console cover.
4. To increase the cable tension, loosen the upper cable
jam nut and tighten the lower cable jam nut
until a force of 156 N (35 lb) applied to the brake lever
handle is required to release the parking-brake latch.
Important: Do not over adjust or the brake band
may drag.
45).
1. Jam nuts
37
(Figure
Figure 46
2. Service brake cable
OFF
45)
g016920
Advertisement
Table of Contents
