Shutting Off The Engine; After Operation; After Operation Safety; Operating The Controls After Mowing - Toro Greensmaster Flex 1021 Operator's Manual

Figure 20
1. Alignment stripes
Operating the Machine in Low
Light Conditions
Use the LED Light Kit when you operate the machine
in low light conditions. Contact your authorized Toro
distributor for this kit.
Important:
Do not use other light systems with
this machine, as they will not operate properly
with the engine AC output.
Operating the Controls while
Mowing
1. Start the engine, set the throttle to a reduced
speed, push down on the handle to raise the
cutting unit, and engage the traction drive
to transport the machine onto the collar or
approach of the green.
2. Stop the machine on the collar or the approach.
3. Increase the throttle speed, engage the cutting
unit, engage the traction drive to move the
machine onto the green, lower the cutting unit to
the ground, and begin mowing.

Shutting Off the Engine

1. Release the clutch bail.
2. Move the throttle control to the S
3. Move the On/Off switch to the O
4. Close the fuel-shutoff valve before you store or
transport the machine

After Operation

After Operation Safety

General Safety
•
Shut off the machine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
g309985
prevent fires. Clean up oil or fuel spills.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Reduce the throttle setting before shutting off
the engine and turn off the fuel-shutoff valve (if
equipped) after mowing.
Operating the Controls
after Mowing
1. Drive the machine off of the green, push down
on the handle to raise the cutting unit, release
the clutch bail, disengage the cutting unit, and
shut off the engine.
2. Remove the grass basket and empty the basket
of clippings.
3. Install the grass basket on the machine and
transport the machine to storage.

Transporting the Machine

After mowing, transport the machine away from the
job site; refer to
Transport Wheels (page 15)
Machine Using a Trailer (page
19
LOW
FF
Transporting the Machine Using
or Transporting the
15).
position.
position.