Hinkley Sculpt 903660FGT-LDD Instruction Manual page 13

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
Light Wires
LED Assembly
Rubber Washers
Washers
Fig. 1
NOTE: Be sure the power is o before installing.
Connect the 2-wire plug from the fan to the 2-wire plug of the LED Assembly.
1
Make sure the connector snaps together.
Carefully tuck the wire connector and wires inside the mounting hub of the motor assembly. Fig.1
Aligning all 4 holes in LED Assembly with 3 holes
2
in the Mounting Hub make sure all screws are tight
(Fig.1 )
3
Raise the glass shade against the LED Assembly and turn
clockwise until snug, DO NOT OVERTIGHTEN.
Restore power and your light kit is ready for operation. (Fig.2 )
Mounting Hub
(bottom of motor)
Screws
Wire connectors
LED
Assembly
Glass shade
Fig. 2
©2019 Hinkley Lighting, Inc.
11
| hinkley.com |