Page 1
52" NEO ™ INDOOR / OUTDOOR LED FAN CONTROL DC MOTOR CEILING FAN INSTRUCTION MANUAL PAIR WITH HINKLEY APP DOWNLOAD ON APP STORE or GOOGLE PLAY HINKLEY...
Page 2
SO WE’RE HERE IF YOU HAVE A QUESTION, NEED SOME HELP OR WANT TO CHAT ABOUT OUR PRODUCTS. SEND SUGGESTIONS OUR WAY TOO—WE’RE ALWAYS LOOKING TO MAKE YOUR EXPERIENCE WITH HINKLEY A POSITIVE ONE. > SERVICE@HINKLEY.COM > 800.HINKLEY > LET’S SEE THAT HINKLEY STYLE @HINKLEY...
If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. | hinkley.com...
flat washers, wire nuts), Blade to Motor Screws and Rubber Washers, MH905452Fxx Balance Kit, Safety cable hardware (wood screw, flat washer) NOTE: Design of parts shown above may look slightly different for your specific model of fan. XX=FAN FINISH | hinkley.com...
Firmly Safety cable clamp tighten screw in the clamp. Cut off excess cable. (Fig. 2) Safety cable loop You are now ready to make the electrical connections. Wood screw and washer Safety cable Fig. 2 | hinkley.com...
Turn the motor housing until the motor housing locks in place at the narrow section of the key holes. Securely tighten the three mounting bracket mounting screws previously loosened and the one previously removed. Motor housing Screws Fig. 1 hinkley.com...
Snap the face plate cover onto the wall bracket. Remote transmitter will be held in place with built in magnets. Cradle B Wall plate Plastic Face plate anchor Transmitter Outlet box Wall plate Cradle A Face plate Transmitter Wall Fig. 1 HIRO Control System Fig. 2 | hinkley.com...
Page 13
Power lead to the fan is connected to the remaining switch lead. (Fig. 4) Attach the cradle A to the wall switch box using the supplied hardware. Attach the multi-gang faceplate to the switch set in the wall outlet box. Cradle A of Hinkley switch will fit in any standard decora face plate.
NOTE: A single fan can be controlled with as many as 3 wall controls in one room. Every control will need to repeat the pairing process based on instructions above and all controls must be within 30 feet of the fan. | hinkley.com...
If the blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight and possibly result in smoother operation. Make sure the mounting plate is securely fastened to the ceiling outlet box. Make sure ceiling box is secure. | hinkley.com...
Page 18
In addition to the included wall control, you can control your Hinkley fan through the Hinkley app. • To use the Hinkley app, download it for free from the App Store or Google Play. • Open the Hinkley app where you will be prompted to create an account.
Page 19
Wait 10 seconds. f) Hold down the Power button on the transmitter you wish to pair. In addition to the included wall control, you can control your Hinkley The fan light should flash three times and the motor spin up for fan through the Bond app.
Page 20
HINKLEY IS PROUD TO PROVIDE YOU WITH CEILING FAN PRODUCTS THAT ENHANCE YOUR SPACE WITH COMFORT, PURPOSE AND STYLE. AS A FAMILY COMPANY, WE ARE COMMITTED TO DESIGN, PERFORMANCE AND QUALITY, AND WHAT’S IMPORTANT TO YOU IS PARAMOUNT TO US.
Page 21
GLOBAL HEADQUARTERS 33000 Pin Oak Parkway | Avon Lake, Ohio 44012 T (440) 653 5500 | F (440) 653 5555 | hinkley.com...