Power Supply/Mains - Philips CDR-600 User Manual

xp CDR 600/17 English 20-03-2001 13:27
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs, these
connections allow you to make digital recordings from various
sources, connected to the receiver.
DIGITAL
RECEIVER
CD RECORDER
1 Connect a digital coaxial cable between the DIGITAL IN-
and OUT sockets on the set and e.g. the (digital) AUX in-
and output sockets on the digital receiver.
Any digital device, connected to the digital input sockets
of the digital receiver (e.g. CD and DVD) can now be
used as recording source.
Pagina 15

Power supply/Mains

1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does not,
consult your dealer or service organisation.
1
1
CDR 2 Make sure all connections have been made before
L
L
CD RECORDER
switching on the mains supply.
R
R
IN
OUT
IN OUT
IN
ANALOG
OPTICAL
DIGITAL
3 Plug the power cord supplied into the AC MAINS ~
connector and the CD recorder, then into the wall socket.
4 Press ON/OFF.
The CD recorder will switch on be displayed.
Notes:
If the CD recorder is in Standby mode (red LED on), press
any key to activate the recorder.
When the CD recorder is in the "OFF" position, it is still
consuming some power. If you wish to disconnect your CD
recorder completely from the mains, withdraw the plug from
the AC Outlet.
Installation
15