Power Supply/Mains; Setup Recommendations; Inserting Batteries In The Remote Control - Philips CDR785/01C User Manual

Audio cd recorder
Hide thumbs Also See for CDR785/01C:
Table of Contents

Advertisement

INSTALLATION

Power supply/Mains

The type plate is located on the rear of the set.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does not,
consult your dealer or service organisation.
2 Make sure all connections have been made before
switching on the AC power supply.
3 Connect the power cord supplied to AC POWER ~ and to the
wall outlet. This switches on the AC power supply.
4 Press ON/OFF to switch on the set.
PHILIPS CD RECORDER will be displayed.
• Press ON/OFF again to switch off the set.
• Press y on the remote control to switch the set to Standby
mode.
When the set is switched to standby, it is still consuming
some power. To disconnect the set from the power
completely, remove the power plug from the wall outlet.
For users in the U.K.: please follow the instructions on
page 3.

Setup recommendations

– Place the set on a solid, vibration free surface.
– Make sure there is sufficient space around the set to
prevent overheating.
– Do not place the set near a source of heat or in direct
sunlight.
– Do not use the set under extremely damp conditions.
– If the set is placed in a cabinet, make sure that a 2.5 cm
space remains free on all sides of the CD recorder for
proper ventilation.
– Active mobile phones near to the set may cause
malfunctions.
16
AC MAIN S

Inserting batteries in the remote control

2x AA, LR6, UM-3 / 1,5 V
1 Open the battery compartment cover.
2 Insert 2 batteries (AA, LR6 or UM-3; as supplied) as shown.
3 Replace the cover.
Note: We recommend you use 2 batteries of the same type
and condition.
Batteries contain chemical substances, so they should
be disposed of properly.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdr785bk99Cdr 785Cdr785bkCdr785/00

Table of Contents