Table of Contents
Advertisement
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 10.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Flip AUTO/OFF/ON
switch to AUTO. Slide the selector switch
to the REMOTE position (see Figure 13).
Note: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
114926-01C
Figure 15 - Correct Pilot Flame Pattern
(Your pilot may vary from pilot shown)
Figure 16 - Incorrect Pilot Flame Pattern
(Your pilot may vary from pilot shown)
www.desatech.com
Thermocouple
11
Advertisement
Table of Contents
