Table of Contents
Advertisement
Removing a damaged storage enclosure chassis from the rack
This section provides a procedure for removing a damaged controller enclosure chassis from its rack
location.
CAUTION: It is recommended that all disk drive modules and air management modules be removed
before removing the enclosure. If this is not possible, two people are required to move the enclosure. See
Removing a disk drive module
1. Make sure that the ear bezels are removed. See
2. Remove the retaining screws that secure the front and rear of the controller enclosure chassis to the rack
and rails.
3. Carefully slide the controller enclosure chassis from the rack.
4. Place the chassis on a work surface near the replacement controller enclosure chassis, the removed disk
drive modules, ear bezel components, and screws.
5. Remove the side bracket from each side of the damaged controller enclosure chassis.
6. Attach the side bracket to each side of the replacement controller enclosure chassis.
Installing the replacement storage enclosure chassis in the rack
This section provides a procedure for installing the replacement controller enclosure chassis in its rack
location.
CAUTION: It is recommended that all disk drive modules and air management modules be removed
before lifting the enclosure. If this is not possible, two people are required to move the enclosure. See
Removing a disk drive module
NOTE: Refer to Rackmount Bracket Kit Installation or 2-Post Rackmount Bracket Kit Installation for the
correct installation procedure and mounting hardware.
1. Attach side brackets (standard rackmount installation) or main brackets (2-post rackmount installation)
on the replacement controller enclosure chassis.
2. Support the bottom of the controller enclosure chassis. Carefully lift/align the chassis and slide it into
the rack.
3. Using the appropriate mounting hardware, secure the controller enclosure chassis to the rack.
4. Install the ear bezels. See
5. Using the applicable retaining screws, secure the front and rear of the controller enclosure chassis to
the rack and rails.
Completing the process
This section provides a procedure for ensuring that the FRU components installed in the replacement
controller enclosure chassis function properly.
1. Reconnect data cables between devices, as needed, to return to the original cabling configuration:
• Between cascaded enclosures.
• Between the controller and peripheral or SAN devices.
• Between the controller enclosure and the host.
2. Reconnect power cables to the controller enclosure. See
3. Turn on the power switch to power supply modules if they are equipped with power switches.
54
Procedures
on page 36.
Removing ear bezel components
on page 36.
Installing ear bezel components
on page 48.
Connecting a power cable
on page 48.
on page 45.
Advertisement
Table of Contents
