Table of Contents
Advertisement
Status Code Display Indications
Warning Indicators
This LCD Projector has a STATUS CODE Display which
calls your attention to problem conditions existing inside
the LCD Projector. The LCD Projector displays a Status
Code Indication each time an internal problem is detected.
If any of the following indications appear in the STATUS
CODE Display, immediately turn off the Main Power
switch, and then see the chart to determine a course of
action.
STATUS
Symptom
CODE
F-L
F-0
A-n
Lamp Unit automatically
turns off due to abnormally
high internal temperature.
A-0
(Stand-by condition)
L-n
P-2
Lamp does not light up.
P-3
P-4
L-1
Lamp operation time is over
1 900 hours.
L-0
Lamp operation time is over
2 000 hours.
Forced cooling fan
C-d
operating to expedite lamp
replacement (See page 51.)
Note
• Please wait one minute before turning the power back on, to allow the lamp to cool. A much longer time may be
required if the projector had attained an abnormally high internal temperature.
Problem
• Cooling fan malfunction.
• Misinstalled Air Filter Unit.
• Temperature Sensor
malfunction.
• Clogged air filter.
• Blocked air intake.
• The surrounding temperature
of the place of use may be
too high.
• Lamp is burned-out.
• Lamp Voltage is not correct.
• Abnormal temperature rise.
• Other causes.
• It is nearly time to replace
the Lamp Unit.
• The Lamp Unit must be
replaced.
Possible Solution
• Take the Projector to your nearest
Service Center.
• Properly install Air Filter Unit
(See page 49.)
• Take the Projector to your nearest
Service Center.
• Clean the filter (See page 49.)
• Relocate projector to a proper
location.
• Place Projector so that surrounding
temperature is between 5 °C (41 °F)
and 40 °C (104 °F) and the humidity is
between 10 % and 80 % (with no
condensation.)
• Take the Projector to your nearest
Service Center.
• Replace the Lamp unit.
(See pages 51, 52.)
STATUS CODE
Display
48
Advertisement
Table of Contents
