Table of Contents
Advertisement
Available languages
Available languages
Device does not connect to the internet
The wind turbine makes a lot of noise.
Green power LED does not light up
The
anemometer is
configured and
there are
revolutions but
there is no wind
measurement
LED does not
flash.
It is working
with only 2
phases.
There is a
mechanical
obstruction.
There are some
fastening
screws to be
tightened.
No power
supply to the
equipment.
Check the
connection of
the
anemometer
because RPMs
are being
detected but
there is no
wind reading
Check
Ethernet
connection
and if cable
has internet
access.
In case of wifi
check
password
(contact
Bornay).
Check the
voltage of all
phases and
the current. It
should be
similar in all 3
phases.
Check the
mechanical
parts of the
wind turbine
and check that
it rotates
without
resistance or
noise.
Re-tighten all
the screws.
Check the
wiring and
measure the
voltage with a
voltmeter.
66
Advertisement
Table of Contents
