Weil-McLain 4 Series Manual page 36

insTallaTion
Baffle Assembly and Installation, continued
1
Assembling the 3rd Flue-Way Baffles, cont.
7 Complete the baffle assembly. Refer to Figure 29.
a Align the slot of the spacer bracket with the
final hole assembly.
b Start the last sheet metal screw into the top of
2
the front baffle.
c Slide the spacer bracket upwards until it
comes in contact with the top side rails
d Complete the threading of the sheet metal
screw to complete the assembly
e Confirm that the spacer bracket is firmly
3
against the top side rails to help space the
assembled baffle in the flue-way.
8 The remaining rectangular halves between the
first and last rectangle baffles do not require
screws Once the two ends have been screwed
together, the middle plates should be close to
4
flush, and the halves should overlap without the
need for any screws
9 Once this first baffle combination has been
assembled, measure the assembly width. Confirm
the width of the assembled baffle matches the
width in Table 9, page 32 for the boiler size
10 Repeat steps 5-7 in this section for all remaining
5
baffle half combinations that were shipped with
the boiler
6
7
8
36
sTeam series
94
Figure 29 Spacer bracket installation
Screw into the Screw into the
aligned baffle holes aligned baffle holes
Left-hand Left-hand
baffle in front baffle in front
boiler manual
4
Slide spacer Slide spacer
bracket up until bracket up until
it contacts the it contacts the
top side rails top side rails
Right-hand Right-hand
baffle behind baffle behind
230143 230143
550-100-157/0523