Foot Switch Connector; Operation Notes - 3rd Power DIRTY SINK 6VEL User Manual

Hide thumbs Also See for DIRTY SINK 6VEL:

Table of Contents

Back Panel (Section Three):

FAN

Foot Switch Connector (24)

To remotely control channel selection, preamp gain boost, FX loop on/off and Hybrid-Master bypass

(lead boost), connect the foot pedal with the 7-pin DIN cable (both the pedal and cable are included

with purchase).

The remote foot-switch allows you to put the DIRTY SINK's 6VEL advanced features under foot con-

trol. The unit includes a high quality 15' 7-Pin DIN cable with a straight plug for the back of the amp

and a right angle plug for use at the pedal. The ampliﬁer provides phantom power through the cable

to drive the LEDs.

• +GAIN: Select FTSW on the +GAIN mini toggle switch located in between the Gain and Volume

control of channel two on the front panel of the ampliﬁer. You may now remotely control your

channel extra gain function.

• Hybrid-MASTER Bypass (Boost): The Hybrid-Master bypass is permanently connected to the FS

Bus circuit. Should you wish to disable the boost, simply turn the Bypass control to zero (fully

counter-clockwise). See page 10 for suggested setting for best use.

• FX Loop On/Off: On the back panel of the amp, place the mini toggle switch in the FTSW posi-

tion. This assigns the loop on/off to the FS Bus. With both +Gain and FX Loop assigned, an ex-

cellent lead solo preset is created where additional gain and sustain come from the preamp, any

effect (such as digital delay) engages, and the volume increases to your speciﬁed preset level -

all with the stomp of a single button on your foot switch.

WARNING:

The DIRTY SINK 6VEL foot switching system cannot share an electrical ground with any other device.

Care should be used when placing your 4 Button foot switch with other devices on a pedal board or

metal tray so as to keep the unit isolated from metal to metal contact.

OHM SELECTOR

16Ω

4Ω

8Ω

Table of Contents