H3C S5500-HI Series Fundamentals Configuration Manual page 61

Step
1. Enter system view.
2. Enable copyright information
display.
3. Enter one or more AUX user
interface views.
4. Configure the baud rate.
5. Configure the parity check
mode.
6. Configure the number of stop
bits.
7. Configure the number of data
bits in each character.
8. Define a shortcut key for
starting a session.
9. Define a shortcut key for
terminating tasks.
10. Configure the flow control
mode.
11. Specify the terminal display
type.
12. Configure the user privilege
level for login users.
Command
system-view
copyright-info enable
user-interface aux first-number
[ last-number ]
speed speed-value
parity { even | none | odd }
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
activation-key character
escape-key { default | character }
flow-control { hardware | none |
software }
terminal type { ansi | vt100 }
user privilege level level
49
Remarks
N/A
By default, copyright information
display is enabled.
N/A
By default, the baud rate is 9600
bps.
The default setting is none, namely,
no parity check.
The default is 1.
Stop bits indicate the end of a
character. The more the bits, the
slower the transmission.
By default, the number of data bits in
each character is 8.
The setting depends on the
character coding type. For example,
you can set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
By default, press Enter to start a
session.
By default, press Ctrl+C to terminate
a task.
By default , the flow control mode is
none.
The device supports only the none
mode.
By default, the terminal display type
is ANSI.
The device supports two terminal
display types: ANSI and VT100.
H3C recommends setting the
display type to VT100 for both the
device and the client. If the device
and the client use different display
types or both use the ANSI display
type, when the total number of
characters of a command line
exceeds 80, the screen display on
the terminal might be abnormal. For
example, the cursor might be
displayed at a wrong place.
3 by default.
This command is not supported in
FIPS mode.